2008 Ford Pickup
Mileage
49,674
Service Date
6/26/2026
Services Performed
- AAA DISCOUNT REWARDS MEMBER CARD # ……………………………
- Roadtest, inspect the integrity of the steering and suspension components, inspect the front and rear tires, inspect for excessive "play" in the wheel bearings and other related components, and advise: Customer States that are vibration is felt from the front end and the truck pulls to the right side as I inspected the car and test drove it I found out that there was no no pulling to the right but the alignment steering wheel is off to the left and as I inspected furthermore I found out that all four tires are badly cupping from inner wall especially the front it's already bald and the front end links are missing bushings. Recommend replacing front tires 245/70R17, balance all four tires, 2 front sway bar links, alignment and continue with the diagnostic.
- A VIBRATION IS FELT FROM THE FRONT END AND THE TRUCK PULLS TO THE RIGHT SIDE.
- STABILIZER BAR CONTROL LINK – Remove & Replace – F150, F250 Super Duty, F350 Super Duty Both
- FUEL FILTER – Remove & Replace – F150 In Line
- WATER PUMP DRIVE BELT – Remove & Replace – F150, Normal – [Includes: Serpentine type Belt(s).]
- Extract the existing brake fluid, replenish the system with fresh fluid, bleed the system of any air or preexisting brake fluid.
- Environmental Waste Disposal Fee, EPA ID# CAL000295851
- Clean the throttle body and butterfly valve, clean the mass air flow sensor, induce a cleaner to service the intake valves, intake plenum, combustion chamber, piston tops, + add a concentrated cleaner to the fuel tank. Take advantage of these cleaning chemicals by filling your fuel tank right away!
- Flush the entire power steering fluid system using a chemical solvent to suspend debris and dissolve varnish, refill and bleed the system using modern flushing equipment, add a system conditioner to extend the hydraulic components life and promote smooth operations.
- Environmental Waste Disposal Fee, EPA ID# CAL000295851
- DIFFERENTIAL SERVICE: REMOVE DIFFERENTIAL COVER, SERVICE THE CARRIER ASSEMBLY, INSTALL COVER, REASSEMBLY, REFILL WITH GEAR OIL
- Inspect and make required adjustments to set "toe", "caster", and "camber" to factory specifications on the front and rear suspension (where applicable). Alignment warranty requires tire rotations and checking tire pressure in accordance with manufacturer's specifications.
- Inspect the tire PSI and Inflate to Proper Specifications Front _____PSI Rear_____PSI
TESS & DAVID G. gave our service a 5 star review on 6/26/2026
