2013 Ford Focus
Mileage
135,143
Service Date
2/28/2025
Services Performed
- STANDARD SYNTHETIC BLEND OIL CHANGE SERVICE: ____ SERVICE LIGHT RESET (This price applies to most cars, SUV's, trucks, and European cars cost extra) ____ LUBE STICKER Quote is for 5 quarts of Multi-grade synthetic blend motor oil per manufacturer specifications, additional quarts, grades, or full synthetic oils extra –OIL AND FILTER CHANGE – Replace the oil drain plug sealing washer where applicable –FULL DIGITAL VEHICLE INSPECTION W/PICTURES –CHECK AND TOP OFF ALL FLUIDS –VISUAL BRAKE INSPECTION FRONT AND REAR –VISUAL CHECK FOR POSSIBLE OIL LEAKS –INSPECT DRIVE BELTS AND HOSES –INSPECT FRONT/REAR WIPER BLADES –INSPECT THE TIRES AND SET TO PROPER PSI ** –INSPECT THE ENGINE AIR FILTER AND CABIN AIR FILTER –INSPECT FRONT AND REAR SUSPENSION –INSPECT FRONT/REAR STRUTS/SHOCKS –PERFORM EXTERIOR VEHICLE LIGHT INSPECTION –INSPECT CV AXLES/BOOTS/DRIVESHAFT(S) –INSPECT STEERING LINKAGE –RESET SERVICE LIGHT –ROAD TEST VEHICLE –CLEAN WINDSHIELD *** ** TIRE ROTATION ADDITIONAL FEE *** WASH VEHICLE WHEN TIME PERMITS
- California Recycling Fee
- Environmental Waste Disposal Fee, EPA ID# CAL000295851
- FOUND:
- Inspect the tire PSI and Inflate to Proper Specifications Front ____35_PSI Rear___35__PSI
- INSPECT FOR COOLANT LEAKS AND ADVISE:
- FOUND: I inspected the vehicle and verified the customer's concerne, that there is a coolant leak present. I performed a cooling system pressure test and inspection and found coolant leaking from the coolant distribution pipe assembly. This assembly is located on the driver side of the cylinder head. Recommend replace coolant distribution pipe assembly. Recommend replace plastic coolant line between expansion tank and water distribution assembly. Recheck and verify proper operation.
- DISASSEMBLE, REPLACE THE COOLANT DISTRIBUTION PIPE ASSEMBLY AND EXPANSION TANK HOSE, REASSEMBLE, REPLENISH COOLANT, BLEED THE SYSTEM.
- DISASSEMBLE, REPLACE THE RIGHT AXLE SHAFT ASSEMBLY, REASSEMBLE.
- * ADJUST THE FRONT AND REAR TOE SLIGHTLY LESS THAN THE MAXIMUM ALLOWED "NEGATIVE" SETTINGS.
- Inspect and make required adjustments to set "toe", "caster", and "camber" to factory specifications on the front and rear suspension (where applicable). Alignment warranty requires tire rotations and checking tire pressure in accordance with manufacturer's specifications.
DAVID M. gave our service a 5 star review on 3/2/2025
