2013 Volkswagen GTI
Mileage
106,771
Service Date
2/28/2025
Services Performed
- AAA DISCOUNT REWARDS MEMBER CARD # ……………………………
- STANDARD VW/AUDI/MINI CAR SYNTHETIC OIL CHANGE SERVICE: ____ SERVICE LIGHT RESET (This price applies to most European cars) Quote is for 5 quarts of Multi-grade synthetic long life motor oil per manufacturer specifications, additional quarts, grades, extra –OIL AND FILTER CHANGE – Replace the oil drain plug sealing washer where applicable –FULL DIGITAL VEHICLE INSPECTION W/PICTURES –CHECK AND TOP OFF ALL FLUIDS –VISUAL BRAKE INSPECTION FRONT AND REAR –VISUAL CHECK FOR POSSIBLE OIL LEAKS –INSPECT DRIVE BELTS AND HOSES –INSPECT FRONT/REAR WIPER BLADES –INSPECT THE TIRES AND SET TO PROPER PSI ** –INSPECT THE ENGINE AIR FILTER AND CABIN AIR FILTER –INSPECT FRONT AND REAR SUSPENSION –INSPECT FRONT/REAR STRUTS/SHOCKS –PERFORM EXTERIOR VEHICLE LIGHT INSPECTION –INSPECT CV AXLES/BOOTS/DRIVESHAFT(S) –INSPECT STEERING LINKAGE –RESET SERVICE LIGHT –ROAD TEST VEHICLE –CLEAN WINDSHIELD *** ** TIRE ROTATION ADDITIONAL FEE *** WASH VEHICLE WHEN TIME PERMITS
- California Recycling Fee
- Environmental Waste Disposal Fee, EPA ID# CAL000295851
- BRAKE INSPECTION: Road test vehicle, visually Inspect the front and rear brake linings, brake hoses, and hydraulic components and advise: RF 7 MM, LF 7 MM RR 6 MM LR 6 MM
- Inspect the tire PSI and Inflate to Proper Specifications Front _38____PSI Rear__38___PSI
- INSPECT AND ADVISE:
- ROAD TEST TO DUPLICATE THE DESCRIBED SYMPTOMS, INSPECT THE EXTERNAL COMPONENTS AND ADJUSTMENTS AND ADVISE: I performed a test drive and duplicated the customer concern. During my test drive I noticed the clutch slipping in more than one gear. I inspected the visually exposed portions of the clutch linkage system and found no obvious faults. The clutch fluid is full with no signs of leaks. Recommend remove transmission for further inspection of clutch assembly components with the anticipation of having to replace clutch assembly
- DISASSEMBLE, REMOVE THE TRANSMISSION OR TRANSAXLE ASSEMBLY TO GAIN ACCESS, REPLACE THE FLYWHEEL OR SUBLET FOR REFINISHING, REPLACE THE CLUTCH PRESSURE PLATE, CLUTCH DISC, RELEASE BEARING AND PILOT BUSHING, REASSEMBLE, REPLENISH FLUID (IF APPLICABLE).
- DISASSEMBLE, REPLACE THE LEFT REAR HUB BEARING ASSEMBLY, REASSEMBLE.
- Replace the battery as required, reassemble with equipped hold-down hardware.
- DISASSEMBLE, REPLACE THE RIGHT FRONT ENGINE MOUNT, REASSEMBLE.
- FOUND: THE INITIAL INSPECTION FOUND LOW COOLANT LEVEL IN THE EXPANSION TANK AND SIGNS OF LEAKAGE. WE PRESSURE TESTED THE SYSTEM AND FOUND NO OBVIOUS LEAKS AT THIS TIME. WE REPLACED THE EXPANSION TANK CAP. MONITOR FOR LEAKS AND ADVISE.
- DISASSEMBLE, REPLACE THE ACCESSORY DRIVE BELT, REASSEMBLE.
JOHN & LINDA B. gave our service a 5 star review on 3/1/2025
