2005 Honda Civic
Mileage
187,545
Service Date
4/8/2022
Services Performed
- AAA DISCOUNT REWARDS MEMBER CARD # ……………………………
- STANDARD SYNTHETIC BLEND OIL CHANGE SERVICE: ____ SERVICE LIGHT RESET (This price applies to most cars, SUV's, trucks, and European cars cost extra) ____ LUBE STICKER Quote is for 5 quarts of Multi-grade synthetic blend motor oil per manufacturer specifications, additional quarts, grades, or full synthetic oils extra –OIL AND FILTER CHANGE – Replace the oil drain plug sealing washer where applicable –FULL DIGITAL VEHICLE INSPECTION W/PICTURES –CHECK AND TOP OFF ALL FLUIDS –VISUAL BRAKE INSPECTION FRONT AND REAR –VISUAL CHECK FOR POSSIBLE OIL LEAKS –INSPECT DRIVE BELTS AND HOSES –INSPECT FRONT/REAR WIPER BLADES –INSPECT THE TIRES AND SET TO PROPER PSI ** –INSPECT THE ENGINE AIR FILTER AND CABIN AIR FILTER –INSPECT FRONT AND REAR SUSPENSION –INSPECT FRONT/REAR STRUTS/SHOCKS –PERFORM EXTERIOR VEHICLE LIGHT INSPECTION –INSPECT CV AXLES/BOOTS/DRIVESHAFT(S) –INSPECT STEERING LINKAGE –RESET SERVICE LIGHT –ROAD TEST VEHICLE –CLEAN WINDSHIELD *** ** TIRE ROTATION ADDITIONAL FEE *** WASH VEHICLE WHEN TIME PERMITS
- California Recycling Fee
- Environmental Waste Disposal Fee, EPA ID# CAL000295851
- FOUND: WE FOUND THE FRONT BRAKE ROTORS WARPED CAUSING A PULSATION WHEN APPLIED. THE FRONT PADS AND ROTORS NEED TO BE REPLACED FOR REPAIR AS WITH THE REAR DRUMS AND SHOES IN THE REAR
- Install premium grade brake pad set, clean and lubricate the caliper guides and hardware, inspect the hydraulic system reassemble and make adjustments as required. Remove brake rotors for resurfacing or replacement.
- Replace brake shoes, clean and lubricate backing plate, clean and inspect hardware, reassemble and make adjustments as required.
- Extract the existing brake fluid, replenish the system with fresh fluid, bleed the system of any air or preexisting brake fluid.
- REMOVE & REPLACE- INSTALL NEW WIPER BLADES
- TIMING BELT- WATER PUMP- TENSIONER AND SEALS – Remove & Replace – 1.7L Eng – [Includes: Adjust Valves.]
- Flush the entire power steering fluid system using a chemical solvent to suspend debris and dissolve varnish, refill and bleed the system using modern flushing equipment, add a system conditioner to extend the hydraulic components life and promote smooth operations.
- SPARK PLUGS – Remove & Replace
- Clean the throttle body and butterfly valve, clean the mass air flow sensor, induce a cleaner to service the intake valves, intake plenum, combustion chamber, piston tops, + add a concentrated cleaner to the fuel tank. Take advantage of these cleaning chemicals by filling your fuel tank right away!
- BALL JOINT – Remove & Replace – Lower,Both – [Serviced in Steering Knuckle Assembly.] – [DOES NOT include alignment.]
- STABILIZER BAR CONTROL LINK FRONT – Remove & Replace – Both
- STABILIZER LINK REAR – Remove & Replace – BOTH
- Rotate the tires and re-balance them. Enjoy a smoother ride while extending tire life!
- Inspect and make required adjustments to set "toe", "caster", and "camber" to factory specifications on the front and rear suspension (where applicable). Alignment warranty requires tire rotations and checking tire pressure in accordance with manufacturer's specifications.
- Inspect the tire PSI and Inflate to Proper Specifications Front _30____PSI Rear__30___PSI
AIMEE B. gave our service a 5 star review on 4/9/2022
