2009 Honda Fit
Mileage
77,630
Service Date
5/17/2022
Services Performed
- AAA DISCOUNT REWARDS MEMBER CARD # ……………………………
- REMOVE THE PASSENGER SIDE DOOR PANEL FOR ACCESS. INSPECT THE WINDOW OPERATION AND ADVISE. NOTE: THE CUSTOMER REMOVED THE FUSE AND HAS IT TAPPED TO THE DASH.
- FOUND: I inspected the passenger side power window and confirmed the client's concern that the window is inoperable. I reinstalled the fuse and checked for power at the motor and found there is no power in the up position. I continued the diagnosis and found there is no signal present from the passenger side window switch. I continued tracing the circuit to the driver side window switch and found power and ground are present at the switch however there is no power out in the up position. This is an indication of an internal failure with the master window switch located on the driver's door. Recommend replacing the master window switch.
- DOOR WINDOW SWITCH – Remove & Replace
- STANDARD SYNTHETIC BLEND OIL CHANGE SERVICE: ____ SERVICE LIGHT RESET (This price applies to most cars, SUV's, trucks, and European cars cost extra) ____ LUBE STICKER Quote is for 5 quarts of Multi-grade synthetic blend motor oil per manufacturer specifications, additional quarts, grades, or full synthetic oils extra –OIL AND FILTER CHANGE – Replace the oil drain plug sealing washer where applicable –FULL DIGITAL VEHICLE INSPECTION W/PICTURES –CHECK AND TOP OFF ALL FLUIDS –VISUAL BRAKE INSPECTION FRONT AND REAR –VISUAL CHECK FOR POSSIBLE OIL LEAKS –INSPECT DRIVE BELTS AND HOSES –INSPECT FRONT/REAR WIPER BLADES –INSPECT THE TIRES AND SET TO PROPER PSI ** –INSPECT THE ENGINE AIR FILTER AND CABIN AIR FILTER –INSPECT FRONT AND REAR SUSPENSION –INSPECT FRONT/REAR STRUTS/SHOCKS –PERFORM EXTERIOR VEHICLE LIGHT INSPECTION –INSPECT CV AXLES/BOOTS/DRIVESHAFT(S) –INSPECT STEERING LINKAGE –RESET SERVICE LIGHT –ROAD TEST VEHICLE –CLEAN WINDSHIELD *** ** TIRE ROTATION ADDITIONAL FEE *** WASH VEHICLE WHEN TIME PERMITS
- Environmental Waste Disposal Fee, EPA ID# CAL000295851
- California Recycling Fee
- REMOVE & REPLACE – CABIN FILTER
- REMOVE & REPLACE – AIR FILTER
- USE THE FACTORY RECOMMENDED OIL TYPE AND QUANTITY.
- FOUND: WE FOUND THE FRONT & REAR BRAKE LININGS IN SPECIFICATIONS AT THIS TIME.
- Extract the existing brake fluid, replenish the system with fresh fluid, bleed the system of any air or preexisting brake fluid.
- Inspect and make required adjustments to set "toe", "caster", and "camber" to factory specifications on the front and rear suspension (where applicable). Alignment warranty requires tire rotations and checking tire pressure in accordance with manufacturer's specifications.
- Inspect the tire PSI and Inflate to Proper Specifications Front __32___PSI Rear__32___PSI
VIKKI & LLOYD R. gave our service a 5 star review on 5/18/2022
