2010 Honda Insight
Mileage
156,156
Service Date
4/17/2024
Services Performed
- AAA DISCOUNT REWARDS MEMBER CARD # ……………………………
- REFERRED BY EVANS TIRE
- THE CUSTOMER STATES THE VENTS ONLY BLOW ON THE DEFROST MODE. INSPECT AND ADVISE ON NEEDED REPAIR.
- FOUND: I inspected the vehicle and verified the client's concern that the HVAC system does not direct air as anticipated. I inspected the mode door operation and found the mode door motor fails to properly operate. Code b1239 is present in HVAC module and indicates there's a short with the mode control motor circuit. I inspected the exposed portions of the wiring and found no indication of a fault. Replacement of the mode door motor will be required. Recommend replacing the mode door actuator, clearing the code and reevaluating the system for additional potential faults. I inspected the HVAC system and confirmed the client's concern that the outlet temperature is warmer than anticipated when set to the max cold setting. I recovered the refrigerant from the system and found the refrigerant level is low. I recharged the system with the proper amount of refrigerant and continued the inspection. I found the HVAC compressor fails to engage. I checked the circuit for power and found there is no power available at the compressor. I checked the fuse for the compressor and found the fuse is good. Diagnostic testing will be required on the HVAC compressor circuit. Recommend performing electrical testing on the HVAC compressor circuit.
- Visual inspections of the system, test pressures, inspect compressor, belt and clutch operation, add refrigerant and retest Post service center outlet temperature: 47°F Post service high side pressure: 190 Post service low side pressure: 30
- REMOVE & REPLACE- MODE DOOR ACTUATOR
- FOUND:
- CONTROL ARM – Remove & Replace – Lower,Both – [DOES NOT include alignment.]
- REMOVE & REPLACE- AIR FILTER
- REMOVE & REPLACE- CABIN FILTER
- TIE ROD &/OR END – Remove & Replace – Outer,Both – [Includes: Adjust toe-in only. NOTE: Deduct .4 if alignment is also performed. NOTE: Manufacturer recommends removal of Rack and Pinion Steering Gear when replacing Inner Tie Rod End(s) on some models. If
- Inspect and make required adjustments to set "toe", "caster", and "camber" to factory specifications on the front and rear suspension (where applicable). Alignment warranty requires tire rotations and checking tire pressure in accordance with manufacturer's specifications.
- STABILIZER BAR CONTROL LINK – Remove & Replace – Both
- Replace the battery as required, reassemble with equipped hold-down hardware.
- CALIFORNIA LEAD ACID BATTERY FEE
- Rotate the tires and re-balance them. Enjoy a smoother ride while extending tire life!
- SHOCK ABSORBER – Remove & Replace – Both
- USE THE FACTORY RECOMMENDED OIL TYPE AND QUANTITY.
- Environmental Waste Disposal Fee, EPA ID# CAL000295851
- Extract the existing brake fluid, replenish the system with fresh fluid, bleed the system of any air or preexisting brake fluid.
- Clean the throttle body and butterfly valve, clean the mass air flow sensor, induce a cleaner to service the intake valves, intake plenum, combustion chamber, piston tops, + add a concentrated cleaner to the fuel tank. Take advantage of these cleaning chemicals by filling your fuel tank right away!
- Pressure test the system, inspect the accessory drive belts and cooling system hoses, drain and refill the cooling system.
- ENGINE OR TRANSMISSION MOUNT – Remove & Replace – Engine,Side
- REMOVE & REPLACE- WIPER BLADES
- STANDARD SYNTHETIC OIL CHANGE SERVICE: ____ SERVICE LIGHT RESET (This price applies to most cars, SUV's, trucks, and European cars cost extra) ____ LUBE STICKER Quote is for 5 quarts of Multi-grade synthetic motor oil per manufacturer specifications, additional quarts, grades, extra –OIL AND FILTER CHANGE – Replace the oil drain plug sealing washer where applicable –FULL DIGITAL VEHICLE INSPECTION W/PICTURES –CHECK AND TOP OFF ALL FLUIDS –VISUAL BRAKE INSPECTION FRONT AND REAR –VISUAL CHECK FOR POSSIBLE OIL LEAKS –INSPECT
BRETT M. gave our service a 5 star review on 4/17/2024
