2007 Toyota 4Runner
Mileage
170,221
Service Date
5/3/2023
Services Performed
- STANDARD SYNTHETIC BLEND OIL CHANGE SERVICE: ____ SERVICE LIGHT RESET (This price applies to most cars, SUV's, trucks, and European cars cost extra) ____ LUBE STICKER Quote is for 5 quarts of Multi-grade synthetic blend motor oil per manufacturer specifications, additional quarts, grades, or full synthetic oils extra –OIL AND FILTER CHANGE – Replace the oil drain plug sealing washer where applicable –FULL DIGITAL VEHICLE INSPECTION W/PICTURES –CHECK AND TOP OFF ALL FLUIDS –VISUAL BRAKE INSPECTION FRONT AND REAR –VISUAL CHECK FOR POSSIBLE OIL LEAKS –INSPECT DRIVE BELTS AND HOSES –INSPECT FRONT/REAR WIPER BLADES –INSPECT THE TIRES AND SET TO PROPER PSI ** –INSPECT THE ENGINE AIR FILTER AND CABIN AIR FILTER –INSPECT FRONT AND REAR SUSPENSION –INSPECT FRONT/REAR STRUTS/SHOCKS –PERFORM EXTERIOR VEHICLE LIGHT INSPECTION –INSPECT CV AXLES/BOOTS/DRIVESHAFT(S) –INSPECT STEERING LINKAGE –RESET SERVICE LIGHT –ROAD TEST VEHICLE –CLEAN WINDSHIELD *** ** TIRE ROTATION ADDITIONAL FEE *** WASH VEHICLE WHEN TIME PERMITS
- California Recycling Fee
- Environmental Waste Disposal Fee, EPA ID# CAL000295851
- Remove the air filter, gently tap to dislodge large inbedded debris, clean the filter as instructed, allow the filter to dry, oil filter as instructed and reinstall.
- REPLACE THE CABIN AIR FILTER
- INSPECT AND ADVISE:
- FOUND: – FRONT PADS ARE NEW BUT EXCESSIVE RUN OUT ON ROTORS CAUSING VIBRATION WHEN BRAKING, REPLACE ROTORS WITH NEW PADS, REAR BRAKE PADS AT 3 MM AND EXCESSIVE RUNOUT, REPLACE REAR BRAKE PADS AND ROTORS – SEE BRAKE SERVICES BELOW
- Install premium grade brake pad set, clean and lubricate the caliper guides and hardware, inspect the hydraulic system reassemble and make adjustments as required. Remove brake rotors for resurfacing or replacement.
- Install premium grade brake pad set, clean and lubricate the caliper guides and hardware, inspect the hydraulic system reassemble and make adjustments as required. Remove brake rotors for resurfacing or replacement.
- Extract the existing brake fluid, replenish the system with fresh fluid, bleed the system of any air or preexisting brake fluid.
- TEST THE HEADLIGHTS (LOW AND HIGH BEAMS), TAIL AND BRAKE LIGHTS, TURN SIGNALS, PARKING LIGHTS, SIDE MARKERS AND ADVISE:
- DISASSEMBLE, REPLACE THE ACCESSORY DRIVE BELT, REASSEMBLE.
- TIE ROD &/OR END – DISASSEMBLE, REPLACE THE RIGHT INNER TIE ROD END AND BELLOWS BOOT, REASSEMBLE.
- Inspect and make required adjustments to set "toe", "caster", and "camber" to factory specifications on the front and rear suspension (where applicable). Alignment warranty requires tire rotations and checking tire pressure in accordance with manufacturer's specifications.
- Inspect the tire PSI and Inflate to Proper Specifications Front 32PSI Rear 32PSI
MEL S. gave our service a 5 star review on 5/3/2023
