2009 Honda Fit
Mileage
10,662
Service Date
3/26/2024
Services Performed
- AAA DISCOUNT REWARDS MEMBER CARD # ……………………………
- OIL CHANGE/ CHECK PASSENGER SIDE WINDOW. THE FUSE WAS REMOVED AS IT WAS VERY SLOW TO ROLL UP.
- FOUND: WE FOUND THE PASSENGER SIDE WINDOW REGULATOR WORKING WHEN FORCING POWER TO THE REGULATOR. AT THIS TIME WE RECOMMEND TO START WITH A NEW MASTER SWITCH AND RECHECK THE SYSTEM OPERATION.
- STANDARD SYNTHETIC BLEND OIL CHANGE SERVICE: ____ SERVICE LIGHT RESET (This price applies to most cars, SUV's, trucks, and European cars cost extra) ____ LUBE STICKER Quote is for 5 quarts of Multi-grade synthetic blend motor oil per manufacturer specifications, additional quarts, grades, or full synthetic oils extra –OIL AND FILTER CHANGE – Replace the oil drain plug sealing washer where applicable –FULL DIGITAL VEHICLE INSPECTION W/PICTURES –CHECK AND TOP OFF ALL FLUIDS –VISUAL BRAKE INSPECTION FRONT AND REAR –VISUAL CHECK FOR POSSIBLE OIL LEAKS –INSPECT DRIVE BELTS AND HOSES –INSPECT FRONT/REAR WIPER BLADES –INSPECT THE TIRES AND SET TO PROPER PSI ** –INSPECT THE ENGINE AIR FILTER AND CABIN AIR FILTER –INSPECT FRONT AND REAR SUSPENSION –INSPECT FRONT/REAR STRUTS/SHOCKS –PERFORM EXTERIOR VEHICLE LIGHT INSPECTION –INSPECT CV AXLES/BOOTS/DRIVESHAFT(S) –INSPECT STEERING LINKAGE –RESET SERVICE LIGHT –ROAD TEST VEHICLE –CLEAN WINDSHIELD *** ** TIRE ROTATION ADDITIONAL FEE *** WASH VEHICLE WHEN TIME PERMITS
- Environmental Waste Disposal Fee, EPA ID# CAL000295851
- California Recycling Fee
- FOUND: WE FOUND THE FRONT & REAR BRAKE LININGS IN SPECIFICATIONS AT THIS TIME.
- DOOR WINDOW SWITCH – Remove & Replace
- TIE ROD &/OR END – Remove & Replace – Outer,Both – [Includes: Adjust toe-in only. NOTE: Deduct .4 if alignment is also performed. NOTE: Manufacturer recommends removal of Rack and Pinion Steering Gear when replacing Inner Tie Rod End(s) on some models. If
- Inspect and make required adjustments to set "toe", "caster", and "camber" to factory specifications on the front and rear suspension (where applicable). Alignment warranty requires tire rotations and checking tire pressure in accordance with manufacturer's specifications.
- Extract the existing brake fluid, replenish the system with fresh fluid, bleed the system of any air or preexisting brake fluid.
- Replace the battery as required, reassemble with equipped hold-down hardware.
- CALIFORNIA LEAD ACID BATTERY FEE
- Inspect the tire PSI and Inflate to Proper Specifications Front __32___PSI Rear__32___PSI
VIKKI & LLOYD R. gave our service a 5 star review on 3/27/2024
