2004 Ford Ranger
Mileage
205,161
Service Date
2/10/2022
Services Performed
- AAA DISCOUNT REWARDS MEMBER CARD # ……………………………
- STANDARD SYNTHETIC BLEND OIL CHANGE SERVICE: ____ SERVICE LIGHT RESET (This price applies to most cars, SUV's, trucks, and European cars cost extra) ____ LUBE STICKER Quote is for 5 quarts of Multi-grade synthetic blend motor oil per manufacturer specifications, additional quarts, grades, or full synthetic oils extra –OIL AND FILTER CHANGE – Replace the oil drain plug sealing washer where applicable –FULL DIGITAL VEHICLE INSPECTION W/PICTURES –CHECK AND TOP OFF ALL FLUIDS –VISUAL BRAKE INSPECTION FRONT AND REAR –VISUAL CHECK FOR POSSIBLE OIL LEAKS –INSPECT DRIVE BELTS AND HOSES –INSPECT FRONT/REAR WIPER BLADES –INSPECT THE TIRES AND SET TO PROPER PSI ** –INSPECT THE ENGINE AIR FILTER AND CABIN AIR FILTER –INSPECT FRONT AND REAR SUSPENSION –INSPECT FRONT/REAR STRUTS/SHOCKS –PERFORM EXTERIOR VEHICLE LIGHT INSPECTION –INSPECT CV AXLES/BOOTS/DRIVESHAFT(S) –INSPECT STEERING LINKAGE –RESET SERVICE LIGHT –ROAD TEST VEHICLE –CLEAN WINDSHIELD *** ** TIRE ROTATION ADDITIONAL FEE *** WASH VEHICLE WHEN TIME PERMITS
- Environmental Waste Disposal Fee, EPA ID# CAL000295851
- California Recycling Fee
- SERVICE THE A/C IF REQUIRED.
- FOUND:
- THERMOSTAT &/OR GASKET – Remove & Replace – V6
- COOLANT TEMPERATURE SENDER OR SENSOR – Remove & Replace – V6,3.0L Eng
- FOUND: WE FOUND THE FRONT BRAKES IN SPECIFICATIONS AT THIS TIME. THE REAR BRAKE DRUMS, SHOES AND HARDWARE SHOULD BE REPLACED FOR REPAIR.
- Replace brake shoes, clean and lubricate backing plate, clean and inspect hardware, reassemble and make adjustments as required.
- Extract the existing brake fluid, replenish the system with fresh fluid, bleed the system of any air or preexisting brake fluid.
- Clean the throttle body and butterfly valve, clean the mass air flow sensor, induce a cleaner to service the intake valves, intake plenum, combustion chamber, piston tops, + add a concentrated cleaner to the fuel tank. Take advantage of these cleaning chemicals by filling your fuel tank right away!
- Flush the entire power steering fluid system using a chemical solvent to suspend debris and dissolve varnish, refill and bleed the system using modern flushing equipment, add a system conditioner to extend the hydraulic components life and promote smooth operations.
- Visual inspections of the system, test pressures, inspect compressor, belt and clutch operation, add refrigerant and retest Post service center outlet temperature: 59 Post service high side pressure: 140 Post service low side pressure: 35
- REMOVE & REPLACE AS REQUIRED FOR REPAIR, INSTALL A NEW SET OF SCHRADER VALVES AND RECHECK THE SYSTEM OPERATION.
- Inspect the tire PSI and Inflate to Proper Specifications Front __35___PSI Rear___35__PSI
MIKE & CHYRISA A. gave our service a 5 star review on 2/14/2022
